Where to plug in the indoor pigtail cable

Connect one end of the pigtail to the device terminal and the other end to the circuit wires using a wire nut or approved connector.

Step-by-Step Connection

1. Turn Off Power Before starting, switch off the circuit breaker controlling the area where you'll work. Verify the power is off using a non-contact voltage tester to ensure safety .
2. Prepare the Pigtail Wires Cut short lengths of wire (typically 6–8 inches) matching the gauge and type of the existing circuit. Strip about 3/4 inch of insulation from each end .
3. Connect to the Device
   • Hot (black) wire: attach to the brass screw terminal.
   • Neutral (white) wire: attach to the silver screw terminal.
   • Ground (bare or green) wire: attach to the green ground screw. Form a clockwise loop on the wire end and tighten the screw securely .
4. Splice to Circuit Wires Gather the incoming and outgoing circuit wires along with the corresponding pigtail wire. Twist them together clockwise using pliers and secure with a wire nut. Ensure no bare copper is exposed and the connection is tight .
5. Finalize Installation Carefully tuck the wires into the electrical box, mount the device, and replace the cover plate. Turn the circuit breaker back on and test the device to confirm proper operation .

Tips for Safety and Reliability

• Use wires of the same type and gauge as the existing circuit.
• Ensure all connections are tight to prevent arcing or overheating.
• Pigtail connections are especially useful for devices that connect multiple circuit wires, preventing downstream outages if a device fails . By following these steps, your indoor pigtail cable will be safely and securely connected, maintaining both circuit integrity and compliance with electrical standards.